W-280B Oscillator Analyzer

  • Comprehensive oscillator waveform analysis
  • Precision time interval analysis of oscillator startup characteristics
  • Selectable test parameters withuser defined QC limits
  • User friendly Windows ®System software
  • All data is published in Microsoft Access™ compatible database in realtime
  • Data can be exported to Microsoft Excel™ for custom data analysis
  • Tests primary output, complementary output, or differential outputs
  • Tests both VCO and enable pin
  • Support for both 6 pin and 4 pin devices
  • Probe Cards available for
    • LVDS, PECL, ECL
    • CMOS, TTL
    • Custom
  • SMD Test Sockets available
    • 5.0x7.5, 5.0x7.0, 4.8x7.3, 3.2x2.5, 2.5x2.0
  • Leaded Test Sockets available for
    • 14 pin DIP/Full and Half
  • Custom Test Sockets

SPECIFICATIONS

Oscillator Frequency Range: 10 KHz to 1 GHz
Oscilloscope Analog Bandwidth: 600 MHz (rise time 1% error at 5 nsec)
Oscillator X10 Probe Bandwidth: 1 KHz to 850 MHz (2.5 K Ohm Max Impedance)
Oscillator X50 Probe Bandwidth: 1 KHz to 500 MHz (12.5 K Ohm Max Impedance)

MEASUREMENTS

  • Start-up Time
  • Rise Time
  • Fall Time
  • Start Frequency
  • Frequency
  • Frequency Min.
  • Frequency Max.
  • Duty Cycle
  • Enable Time
  • Supply Current
  • Logic High Level
  • Logic Low Level
  • Short Test
  • Open Test
  • Period
  • Peak to Peak Voltage
  • RMS Voltage
  • Linearity
  • High Pull
  • Low Pull
  • Total Pull
  • Power
  • Tri-State
  • Bin
  • Date
  • Time
  • Jitter

SYSTEM CONFIGURATION

  • Bench Top Fixture
  • Two Probe Cards
  • Oscilloscope
  • Chassis (optional)
  • Printer (optional)
  • Computer (minimum Pentium III, 2 PCI slots, 1 full size PCI slot)
  • S&A MFC-100 Card (requires full size PCI slot)
  • Windows ®based System Software
  • Network Router