250B/6SA Dual Plating System Upgrade

  • Extends the frequency range of the SC-6SA Plating System1 to 200 MHz
  • Precision plating to load resonant frequency using "Measured FL" method
  • Increases frequency accuracy
  • No physical capacitor is required
  • Uses existing filaments and crystal wheels
  • Two Pass plating
  • Over 40 different crystal parameter
    measurements including DLD and
    Spurious
  • Measured parameters checked
    against user defined QC limits
    (No ring test required)
  • Supports wheels with different
    number of positions (e.g. 72 or 144)
  • Upgrade can be configured for a variety of plating system models
  • Each 6SA system runs independently
1SC-6SA is a trademark of Showa Shinku Corporation, Japan

SPECIFICATIONS

Frequency Range: 1 MHz to 200 MHz
Plating Performance: ± 2 ppm* at series, typical
Network Analyzer: 250B-1
* Proprietary measurement and calibration algorithms provide correlation to industry standard crystal measurement equipment.

SYSTEM CONFIGURATION

  • S&A 250B-1 Network Analyzer
  • Dual Relay Assembly
  • Two 6SA Vacuum Feedthru Assemblies
  • Windows® based System Software
  • S&A PCI TTL I/O Card
  • Two IEC-444 PI Networks
  • Computer Requirement:
    Minimum 500 MHz Pentium III, full PCI slot with +5V & 3.3V power

SCREEN FORMAT