6300239-01  SCREEN FORMAT  •  PCI TTL I/O Card  •  IEC-444 PI Network  •  Computer Requirement:  Minimum 500 MHz Pentium III,
full PCI slot with +5V & 3.3V power  SYSTEM CONFIGURATION  •  250B Network Analyzer  •  250B/6SA Relay Assembly  •  6SA Vacuum Feedthru Assembly  •  System Software

 S&A  •  Extends the frequency range of the  
SC-6SA Plating System¹ to 200 MHz  •  Increases frequency accuracy  •  Precision plating to load resonant frequency
using "Measured FL" method  •  No physical capacitor is required  •  Uses existing filaments and crystal wheels  •  Two Pass plating  •  Over 40 different crystal parameter         
measurements including
DLD and Spurious  •   Measured parameters checked
against user defined QC limits
(No ring test required)  •  Supports wheels with different
number of positions  (e.g. 72 or 144)  •  Upgrade can be configured for a
variety of plating system models  Frequency Range :  1 MHz - 200 MHz  Plating Performance :  +/-2 ppm  at series, typical *  Typical Process Time
(144 Position Wheel) :  10 minutes + pump down time  Network A nalyzer :  250B  *  Proprietary measurement and calibration algorithms provide correlation to  industry standard crystal measurement equipment.  SPECIFICATIONS  ¹SC-6SA is a trademark of Showa Shinku Corporation, Japan  250B/6SA PLATING SYSTEM  UPGRADE