FACILITY REQUIREMENTS * Oscillator Frequency in Hz and PPM MEASUREMENTS * 16 Key Keypad * Strip Printer - 2.25" (57.5mm) * System Software * VCXO Power Supply (Optional) * Quartz Crystal Plating (Optional) * Computer * S&A Frequency Counter Card * Direct Drive Roughing Pump * Cryo, Diffusion, or Turbo Pump * 5 Volt Oscillator Power Supply DEVICE TYPES * 8 or 14 pin Standard Oscillators * Voltage Controlled Oscillators * Custom Packages * Surface Mount SYSTEM CONFIGURATION * Power: 220 or 380 Volts, 3-Phase, 15 Amps * Inlet Pressures: 150 PSIG Maximum * Air: 90 PSIG * Nitrogen: 20 PSIG * Water Cooling (Diffusion): 0.15 GPM @ 60 to 80 Deg. F (16 - 27 Deg. C) * Dimensions: 22 x 70 x 40 inches (55.9 x 177.8 x 101.6 cm) SAUNDERS & ASSOCIATES, INC. 6300133-07

S&A 5400S
PLATING SYSTEM * Oscillator final frequency adjust plating system * Vertical evaporation and pulse width modulation of
filament power results in minimum plating material
usage * Single aperture with three axis adjustment for
simple plating spot alignment * Oscillators of different frequencies can be plated
in one run * Optimizes work area by using minimal floor space * Compares measured parameters against simple to
adjust user defined QC limits SPECIFICATIONS Frequency Range: 1 KHz - 300 MHz Plating Performance: +/- 2 ppm typical final frequency Through put: 400 units/hour,typical * Plates and measures TTL/CMOS/ECL
devices * Proprietary magnetic wheel uses no
sockets for DIP packages * Contacts directly to oscillator leads